A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.
Not every Lexington Park, MD basement needs full-perimeter drain tile — sometimes a targeted section addressing the actual entry point is the more cost-effective, equally durable fix. We size the scope to what the inspection actually shows.
We're licensed and insured for residential and light commercial interior drainage work across Lexington Park, MD.
Interior drainage installs are scheduled locally, without routing through a national call center that adds weeks to the timeline.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Drain tile that isn't sloped correctly simply won't move water — we verify slope with a level during installation, not just by eye.
We scope every Interior Drainage System job in person before quoting it, since two properties with the same symptom rarely need the same fix.
A channel is cut along the slab edge, perforated pipe is laid with proper slope, and gravel backfill allows water to flow freely into the drain.
Basin placement is chosen for the shortest, most direct discharge path away from the foundation.
This option works well as a lower-disruption alternative to full perimeter drain tile in certain Lexington Park, MD basement layouts.
The cove joint where wall meets floor is sealed and tied directly into the drain system so water is captured right at the entry point.
Existing drain tile that's clogged with silt or has failed slope can often be cleaned or repaired rather than fully replaced.
Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
We also check existing drainage, if any, to determine whether repair or new installation makes more sense.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
We test the system with water flow before finishing to confirm proper slope and basin performance.
"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Lexington Park Homeowner
"Cove joint had been the source of our leak for years and nobody had addressed it until now."
— Lexington Park Customer
"They tested the system with a hose before calling it done, which gave us confidence it would actually work in a real storm."
— Lexington Park Homeowner
"Sump basin placement was smarter than what a previous contractor had proposed — shorter discharge run, less noise."
— Lexington Park Customer
Full perimeter systems make sense when multiple walls show signs of intrusion or as preventive coverage.
Drain tile requires cutting the slab; a baseboard channel is a lower-disruption alternative that captures wall seepage without floor demolition.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
Basin size is based on expected water inflow from the drain tile's linear footage and your Lexington Park, MD area's typical rainfall intensity.
Cutting the slab does involve some disruption, but we work in sections and clean up debris as we go.
We give you a realistic timeline in the written quote based on your specific basement layout.
We install and repair interior drainage systems throughout Lexington Park and the surrounding Lexington Park, MD service area, including the zip codes listed below.
Zip codes we serve in Lexington Park, MD: 20653
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
